NOTE: Certain carpets and low humidity conditions may generate small static discharges. Do not place vacuum close enough to objects to pull into rotating brush. Never place Powerfoot on furniture or uneven surfaces. Never place fingers under the vacuum when it is running. NOTE: Rotating floor brush continues to rotate while tools are in use.
If the cord doesn’t fully retract on the first try, pull a little bit of cord out and press the rewind button again. Hold onto the plug and press the automatic cord rewind button until it’s fully retracted. When you finish using your vacuum, unplug it from the outlet. Once you have the desired amount of cord, plug it into the outlet.Ģ. To plug your vacuum in, gently pull the cord out of the automatic cord rewind and stop at the yellow mark on the cord. If your vacuum is difficult to push, adjust to the next higher setting. TIP: For optimal carpet cleaning performance, adjust to the lowest practical setting. Highest setting – For high pile and most shag carpet. To pick up debris, it may be necessary to move up one setting. Lowest setting – For low pile carpet or bare floors. If the dial is difficult to turn, tilt the vacuum back slightly to take the weight off the foot while turning. Turn the dial on the foot of the vacuum to the desired setting. Press the recline pedal and pull handle back towards you.ģ. Press the red power button with your foot to turn the vacuum ON and once again to turn your vacuum OFF. Always place vacuum on floor with handle in upright position when using tools.ġ. Do not carry the vacuum while it is running. WARNING To reduce the risk of injury from moving parts while the vacuum is turned on, always move the vacuum via the rolling wheels by using the upper handle at the back of the vacuum.
NOTE: The Powerfoot will not suction properly unless the hose is firmly attached. Now, put your accessory tools on the vacuum and you’re ready to go! Wrap hose up and around the hose wrap on the handle. Insert the hose end into the back of the vacuum and twist right to lock in place.Ĥ. Insert the extension wand base and turn it to the right to lock in place.ģ. Then attach the handle with the 2 screws taped to the handle in a plastic bag.Ģ. Place the upper handle onto the base and push it down. The only tool you will need to assemble your vacuum is a Phillips screwdriver.ġ. NOTE: The Crevice Tool is stored inside the Extension Wand. Crevice Tool (stored inside Extension Wand).
#Bissell cleanview rewind pet bagless vacuum cleaner manual#
Bissell 2254 CleanView® Swivel Rewind Pet Upright Bagless Vacuum - Use Manual - Use Guide PDF.
0 kommentar(er)
